With the new Eversolo C10, you can watch the oscillator warm up. An 8.8-inch touchscreen displays the temperature curve of the quartz oscillator and its operating status in real time. Technically, the master clock complements Eversolo’s 10 Series by providing a common clock reference for appropriately equipped digital audio components.
Heated SC-Cut Quartz as the Time Base
At its core is a specially manufactured 10-MHz OCXO. The acronym stands for Oven-Controlled Crystal Oscillator—that is, a quartz oscillator with temperature-controlled heating. The constant operating temperature is designed to minimize the impact of fluctuating ambient temperatures on the clock frequency.
Eversolo uses a quartz crystal with an SC cut. Its geometry is designed to reduce sensitivity to temperature changes and mechanical stress. A PLL control loop and the manufacturer’s proprietary Reference Timing Engine coordinate the oscillator, calibration, and output stages.
Eversolo specifies a phase noise value of no more than −115 dBc/Hz at a frequency offset of 1 Hz from the carrier frequency. The factory-set frequency deviation is specified to be less than ±0.01 ppm at 10 MHz and 25 degrees Celsius.

Four BNC outputs for compatible devices
The C10 features four separately buffered BNC clock outputs that all draw from the same internal reference. The independent buffering is designed to limit load-induced interference between the connected components.
There are nine output frequencies to choose from between 10 and 100 MHz, including 10, 25, and 100 MHz, as well as references for the 44.1- and 48-kHz frequency families. The outputs provide a square-wave signal at 50 ohms output impedance.
The C10 is designed for compatible streamers, CD drives, and D/A converters with a suitable external clock input. Eversolo lists the T10 streaming transport and the Z10 DAC as compatible devices. The clock frequency, signal shape, and electrical connection specifications must match the requirements of the connected devices.
Temperature Curve and External Calibration
The IPS display shows the warm-up phase, the subsequent stabilization, and stable operation. It also provides information on calibration via an external 1PPS reference. Such an input expects one pulse per second and can be fed, for example, by a suitable GNSS receiver. This allows the internal time base to be recalibrated over the long term.
The power supply uses a toroidal transformer. Separate circuit sections, electrical isolation, and shielding are designed to reduce interference with the clock system. The USB port is used exclusively for system updates.
Price and Availability
The aluminum enclosure measures 365 × 88 × 310 millimeters (W × H × D), including the feet, and the device weighs 5.85 kilograms. Two clock cables, measuring 0.5 and 1 meter in length, are included.
The Eversolo C10 is available for pre-order now and is expected to be available starting in mid-December 2026 for 1,880 euros. audioNEXT will handle distribution in Germany and Austria.
More information: Eversolo C10 from the manufacturer




